Advanced Energy Technologies
Mohammad Rahimzadeh; Hamid Samadi; Nikta Shams Mohammadi
Abstract
Energy harvesting from ambient vibrations using piezoelectric cantilevers is one of the most popular mechanisms for producing electrical energy. Recently, efforts have been made to improve the performance of energy harvesters. The output voltage dramatically depends on the geometrical and physical parameters ...
Read More
Energy harvesting from ambient vibrations using piezoelectric cantilevers is one of the most popular mechanisms for producing electrical energy. Recently, efforts have been made to improve the performance of energy harvesters. The output voltage dramatically depends on the geometrical and physical parameters of these devices. In addition, improved performance is often achieved by operating at or near the resonance point. So, this paper aims to reduce the natural frequency to match the environmental excitation frequency and increase the harvested energy. For this purpose, different geometrical and physical parameters are studied to determine the impact of each parameter. These parameters include the length, thickness, density, and Young’s modulus of each layer. The beam is considered a unimorph cantilever with rectangular configuration and the study is performed using COMSOL Multiphysics software. The results are compared with those obtained by an analytical approach. The results show that changing the parameters made the natural frequency of the system vary in the range of 20 Hz to 200 Hz and increased the output voltage up to 20 V.
Advanced Energy Technologies
Abubakari Zarouk Imoro; Moses Mensah; Richard Buamah
Abstract
This study was conducted to improve the voltage production, desalination, and COD removal efficiencies of a five-chamber Microbial Desalination Cell (MDC). To do this, rhamnolipid was added to anolytes only and catholytes stirred to determine the effects of these factors on the MDC activity. This was ...
Read More
This study was conducted to improve the voltage production, desalination, and COD removal efficiencies of a five-chamber Microbial Desalination Cell (MDC). To do this, rhamnolipid was added to anolytes only and catholytes stirred to determine the effects of these factors on the MDC activity. This was followed by a factorial study to investigate the effects of the interactions of rhamnolipid and stirring on the voltage production, desalination, and COD removal efficiencies of the MDC. Increasing the concentration of rhamnolipid to 240 mg/L improved the peak voltage produced from 164.50 ± 0.11 to 623.70 ± 1.32 mV. Also, the desalination efficiency increased from 20.16 ± 1.97 % when no rhamnolipid was added to 24.89 ± 0.50 % at a rhamnolipid concentration of 240 mg/L, and COD removal efficiency increased from 48.74 ± 8.06 % to 64.17 ± 5.00 % at a rhamnolipid concentration of 400 mg/L. In the stirring experiments, increasing the number of stirring events increased peak voltage from 164.50 ± 0.11 to 567.27 ± 18.06 mV. Similarly, desalination and COD removal efficiencies increased from 20.16 ± 1.97 % and 48.74 ± 8.06 % to 24.26 ± 0.97 % and 50.23 ± 1.60 %, respectively, when the number of stirring events was more than twice a day. In the factorial study, voltage production, desalination, and COD removal efficiencies were 647.07 mV, 25.50 %, and 68.15 %, respectively. However, the effect of the interaction between rhamnolipid and stirring was found to be insignificant (p>0.05). Thus, the addition of only rhamnolipid or the stirring of catholytes only can improve the performance of the five-chamber MDC.